Skip to main content
To KTH's start page

Publications

Publication list from DiVa

[1]
T. Ruan et al., "A new optimal PV installation angle model in high-latitude cold regions based on historical weather big data," Applied Energy, vol. 359, 2024.
[2]
M. Billson et al., "Acoustic Cavity Resonances Driven by Shear Layer Instability," in 30th AIAA/CEAS Aeroacoustics Conference, 4 June - 7 June 2024, Rome, Italy, 2024.
[3]
M. Khalid et al., "Impact of public and residential smart EV charging on distribution power grid equipped with storage," Sustainable cities and society, vol. 104, 2024.
[4]
J. Thiyagarajan et al., "Matching of an overhung volute to a centrifugal compressor at varied operating conditions," in Proceedings of ASME Turbo Expo 2024: Turbomachinery Technical Conference and Exposition, GT 2024, 2024.
[5]
C. Tavera Guerrero et al., "Numerical surface roughness influence on the aerodamping of an axial transonic compressor at nominal speed and part-speed," in Proceedings of ASME Turbo Expo 2024: Turbomachinery Technical Conference and Exposition, GT 2024, 2024.
[6]
J. Thiyagarajan et al., "Performance Analysis of Centrifugal Compressor Stage using Detailed Component Level Measurements," International Journal of Gas Turbine, Propulsion and Power Systems, vol. 15, no. 3, pp. 58-66, 2024.
[7]
T. Ruan et al., "Pv-load matching based on combination of different consumers : A case study in Swedish contexts," Solar Energy, vol. 281, 2024.
[8]
N. Glodic et al., "ARIAS project- Summary of project results," , 2023.
[9]
F. Padovani, M. Topel and B. Laumert, "Case Study of Shared Solar Applications in a Swedish Energy Community," in Proceedings of 2023 IEEE PES Innovative Smart Grid Technologies Europe, ISGT EUROPE 2023, 2023.
[10]
T. Ruan et al., "Potential of grid-connected decentralized rooftop PV systems in Sweden," Heliyon, vol. 9, no. 6, 2023.
[11]
P. Costa Nascimento and M. Topel, "PROBABILISTIC EVALUATION OF PLUG-IN ELECTRIC VEHICLES IMPACTS ON THE STEADY-STATE PERFORMANCE OF A DISTRIBUTION NETWORK IN STOCKHOLM," in IET Conference Proceedings, 2023, pp. 1070-1074.
[12]
J. Thiyagarajan et al., "Study of the Variation in Component Level Characteristics of a Centrifugal Compressor Across the Compressor Map Using CFD and Experiments with Detailed Instrumentation on a Gas Stand," in Proceedings of ASME Turbo Expo 2023 : Turbomachinery Technical Conference and Exposition, GT 2023, 2023.
[13]
N. Glodic, C. Tavera Guerrero and M. Gutierrez, "Aeroelastic Response of a Transonic Compressor Cascade at High Reduced Fequencies," in Proceedings of ISUAAAT16, 2022.
[14]
A. P. Chalke, N. Glodic and M. Gutierrez, "Aeroelastic Tailoring of Compressor Blades," in ICAS PROCEEDINGS of 33th Congress of the International Council of the Aeronautical Sciences, Stockholm, Sweden, 2022.
[15]
N. Glodic, C. Tavera Guerrero and M. Gutierrez, "Blade oscillation mechanism for aerodynamic damping measurements at high reduced frequencies," in E3S Web Conf.Volume 345, 2022XXV Biennial Symposium on Measuring Techniques in Turbomachinery (MTT 2020), 2022.
[16]
N. Glodic et al., "Bringing turbomachinery aeromechanics research closer to education," in ISUAAAT16, 2022.
[17]
S. Hammer, J. Fridh and M. Billson, "IDENTIFICATION OF CRITICAL ACOUSTIC MODES FOR AN OPEN BOX CAVITY WITH ADJUSTABLE DEPTH," in 33rd Congress of the International Council of the Aeronautical Sciences, ICAS 2022, 2022, pp. 2910-2922.
[18]
T. Grönstedt et al., "MULTIDISCIPLINARY ASSESSMENT OF A YEAR 2035 TURBOFAN PROPULSION SYSTEM," in 33rd Congress of the International Council of the Aeronautical Sciences, ICAS 2022, 2022, pp. 4981-4990.
[19]
S. Thantla et al., "Performance Analysis of a Dual-loop Organic Rankine Cycle System for Waste Heat Recovery from Engine Coolant and Exhaust of a Heavy-Duty Truck," Applied Thermal Engineering, vol. 219, no. part A, 2022.
[20]
C. Tavera Guerrero, N. Glodic and H. Mårtensson, "STEADY-STATE AERODYNAMICS TIP GAP INFLUENCE IN A TRANSONIC LINEAR CASCADE AT NEAR STALL," in 33rd Congress of the International Council of the Aeronautical Sciences, ICAS 2022, 2022, pp. 2131-2140.
[21]
C. Tavera Guerrero, N. Glodic and M. Hans, "Steady-state aerodynamics tip gap influence in atransonic linear cascade at near stall," in 33rd Congress of the International Council of the Aeronautical Sciences (ICAS), Stockholm, 4–9 September 2022, 2022.
[22]
C. Tavera Guerrero, N. Glodic and P. Groth, "Validation of Steady-State Aerodynamics in a Transonic Linear Cascade at Near Stall Conditions," in Proceedings of the ASME Turbo Expo, 2022.
[23]
C. Tavera Guerrero et al., "Validation of unsteady aerodynamics in a transonic linear cascade at first flex modeshape at near stall conditions," in ISUAAAT 16, 2022.
[24]
M. Arnaudo et al., "Corrigendum to ‘waste heat recovery in low temperature networksversus domestic heat pumps - A techno-economic and environmentalanalysis’ Energy 219 (2021) 119675," Energy, vol. 221, 2021.
[25]
J. Rijpkema et al., "Experimental investigation and modeling of a reciprocating piston expander for waste heat recovery from a truck engine," Applied Thermal Engineering, vol. 186, 2021.
[26]
S. Hammer, J. Fridh and M. Billson, "Experimental Investigation of Rossiter Modes for an Open Box Cavity With Adjustable Depth," in Proceedings of the ASME Turbo Expo, 2021.
[27]
A. S. Roy et al., "Flow instability effects related to purge through a gas turbine chute seal," Journal of the Global Power and Propulsion Society, vol. 5, pp. 111-125, 2021.
[28]
M. Arnaudo et al., "Heat recovery and power-to-heat in district heating networks – Atechno-economic and environmental scenario analysis," Applied Thermal Engineering, vol. 185, pp. 116388, 2021.
[29]
Y. Gao et al., "Numerical Investigation of the Performance Impact of Stator Tilting Endwall Designs on a Mixed Flow Turbine," INTERNATIONAL JOURNAL OF TURBOMACHINERY PROPULSION AND POWER, vol. 6, no. 2, pp. 14, 2021.
[30]
J. C. Heldens, J. Fridh and J. Ostlund, "On the characterization of methane in rocket nozzle cooling channels," Acta Astronautica, vol. 186, pp. 337-346, 2021.
[31]
M. Arnaudo et al., "Waste heat recovery in low temperature networks versus domesticheat pumps - A techno-economic and environmental analysis," Energy, vol. 219, 2021.
[32]
J. T. M. Horwood et al., "Flow Instabilities in Gas Turbine Chute Seals," Journal of engineering for gas turbines and power, vol. 142, no. 2, 2020.
[33]
T. Gezork and P. Petrie-Repar, "Influence of Gap Detailing on Calculated Unsteady Non-Adjacent Blade Row Aero-Forcing in a Transonic Compressor Stage," Journal of turbomachinery, vol. 142, no. 11, 2020.
[34]
M. Topel and J. Grundius, "Load Management Strategies to Increase Electric Vehicle Penetration-Case Study on a Local Distribution Network in Stockholm," Energies, vol. 13, no. 18, 2020.
[35]
J. C. Heldens, J. Fridh and J. Östlund, "On the characterization of methane in rocket nozzle cooling channels," in Proceedings of the International Astronautical Congress, IAC, 2020.
[36]
M. Arnaudo, M. Topel and B. Laumert, "Techno-economic analysis of demand side flexibility to enable the integration of distributed heat pumps within a Swedish neighborhood," Energy, vol. 195, 2020.
[37]
M. Arnaudo, M. Topel and B. Laumert, "Vehicle-to-grid for peak shaving to unlock the integration of distributed heat pumps in a swedish neighborhood," Energies, vol. 13, no. 7, 2020.
[38]
M. Gutierrez et al., "A Mistuned Forced Response Analysis of an Embedded Compressor Blisk Using a Reduced-Order Model," Journal of engineering for gas turbines and power, vol. 141, no. 3, 2019.
[39]
S. Tian et al., "CFD-Aided Design of a Transonic Aeroelastic Compressor Rig," Journal of turbomachinery, vol. 141, no. 10, 2019.
[40]
S. Thantla et al., "Characterization of an organic Rankine cycle system for waste heat recovery from heavy-duty engine coolant and exhaust," in 5th International symposium on ORC power systems, 9 – 11 September 2019, Athens, 2019.
[41]
T. Sun et al., "Detached-Eddy Simulation Applied to Aeroelastic Stability Analysis in a Last-Stage Steam Turbine Blade," Journal of turbomachinery, vol. 141, no. 9, 2019.
[42]
J. T. M. Horwood et al., "FLOW INSTABILITIES IN GAS TURBINE CHUTE SEALS," in PROCEEDINGS OF THE ASME TURBO EXPO : TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, 2019, VOL 5B, 2019.
[43]
Y. Gao et al., "FORCED RESPONSE ANALYSIS OF A RADIAL TURBINE WITH DIFFERENT MODELLING METHODS," in PROCEEDINGS OF THE ASME TURBO EXPO : TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, 2019, VOL 7A, 2019.
[44]
M. Arnaudo et al., "Heat demand peak shaving in urban integrated energy systems by demand side management - A techno-economic and environmental approach," Energy, vol. 186, 2019.
[45]
T. Sun et al., "Influence of the Tip Clearance on the Aeroelastic Characteristics of a Last Stage Steam Turbine," Applied Sciences, vol. 9, no. 6, 2019.
[46]
S. Thantla et al., "Performance Analysis of Volumetric Expanders in Heavy-Duty Truck Waste Heat Recovery," in 2019 JSAE/SAE Powertrains, Fuels and Lubricants, 26 August 2019 through 29 August 2019, 2019.
[47]
M. Gutierrez Salas et al., "A mistuned forced response analysis of an embedded compressor blisk using a reduced order model," in Proceedings of the ASME Turbo Expo 2018: Turbomachinery Technical Conference, 2018.
[48]
M. Topel et al., "Analysis of plant performance with improved turbine flexibility : Test case on a parabolic trough configuration," in AIP Conference Proceedings, 2018.
[49]
T. Sun, P. Petrie-Repar and D. Vogt, "Detached-eddy simulation applied to the tip-clearance flow in a last stage steam turbine blade," in ASME Turbo Expo 2018: Turbomachinery Technical Conference and Exposition, 2018.
[50]
M. Pan et al., "Determination of aerodynamic damping at high reduced frequencies," in Proceedings of the ASME Turbo Expo, 2018.
Full list in the KTH publications portal